How do I use a .bsg file?

Accidental hybrid engine

uploaded by oziboy 2 years ago

Okay, so this was purely created by accident, I was just messing around doing an attempt to make a better type of valve system
And I think I did
And I created this thing

Long story short, by placing that hinge for the piston's firing mechanism in combination with the turbine-ish creation in the bottom I realised that I could make some sort of continuous power

This was actually a pretty crappy build, but a smooth one, until I realised that

So what it does is, the piston gets pushed by the top steam cannon
The steam cannon goes upwards under its own power, which helps drive the crankshaft downwards, THEN in the bottom there's 2 steam cannons, one lifts up the power of the top cannon and one is for more power, push both of the blocks back upwards, and the top steam cannon goes down again, and there's a wing attached to it so after the lower steam cannons are done pushing the block, it gets out of the way and they push the wing for a little, again until the blocks are there, which gives the wing enough time to move back

Basically, this is continuous power and I'm pretty excited about it
This gotta be relatively my best creation every
And even better, it's pure vanilla!

Instructions: Wait for cannons to heat up and Y to start engine
posted by Dieguitoman 2 years ago
Like the peacemaker or the fireworks!
posted by MaLscrypt 2 years ago
almost died reading that paragraph
posted by oziboy 2 years ago
Sorry hehehe
posted by Roycehellion 2 years ago
Interesting, it was easier to just look at it run than read that :P
posted by oziboy 2 years ago
TL;DR: Messed around, no mods, made engine with hybrid turbine/piston design