How do I use a .bsg file?

RTC elevon assembly

uploaded by sazabi2001 1 month ago


An extension of the 14 blocks aileron design with additional elevator on the same control surface. Only 5 blocks added to the original design, now a total of 19 blocks with 2-way completed RTC control. Both roll-rate and pitch-rate are reasonably high, and their motion would not conflict with each other.

I believe this is one of the most compact (if not the most) RTC control for all vanilla aircraft design, take minimum blocks and space and could be an alternative to gyroscope control.

Drawbacks are the same as aileron
Swivel joint may be weak for high load, recommend reinforcing with hinge if needed.
Asymmetry design, roll-rate may vary on 2 sides.
Can only use near fuselage center-line, the further away from center-line, the more stress it would suffer.
Only 1 block for hard-point, a bit weaker than the aileron with 2 hard points.

Note: blocks with green pin can be used as hard points.
No comments to display.